Both springs, matched to the weight
One broken spring is a pair that has done its work. We size the set to the leaf. We do not hang a leftover coil from another door.
Garage door spring replacement in Somerset West — snapped or tired springs matched to door weight. Both springs as general practice, not a patented method.
Garage-door springs take the weight of the leaf. When one snaps, the door sits dead or the motor strains, and the remaining spring is usually tired. Somerset West Garage Doors replaces springs on sectional, roll-up and tip-up doors in Somerset West, Strand and Gordon's Bay. Replacing both, and matching them to the door weight — meranti is not Aluzinc — is general practice. It is not a patented method and not a reason to buy a leftover coil. A spring job is still a visit: we look at cables, drums, balance and whether the leaf itself is finished. A motor that has been lifting an under-sprung door may have suffered; we will say so. We will not invent an interval at which every Helderberg spring must be changed. If the door is off-track or the cables are frayed, those sit on the hardware card and are part of the same honest scope.
One broken spring is a pair that has done its work. We size the set to the leaf. We do not hang a leftover coil from another door.
A door that will not lift is often a spring. We look at balance before we specify a new operator.
A spring visit is a chance to see drums, cables and alignment. Related hardware is scoped, not dumped as a surprise.
The work is assessed according to use, condition, access and the result required.
Send the address or suburb, the spring replacement requirement, approximate extent and a few photos. The reply can then focus on the actual Somerset West site.
Somerset West Garage Doors provides garage doors services in Somerset West. The address, access, existing condition and intended result are reviewed before the work is scoped.
Property access, parking, neighbouring boundaries and working space vary across Somerset West and can change how the project is planned. This is checked against the spring replacement scope.
The existing surface, finished levels and water path are checked at the actual Somerset West address before recommendations are made. This is checked against the spring replacement scope.
The specification is matched to how the area will be used, the expected load and the finish the property needs. This is checked against the spring replacement scope.
You send photos of the door and the suburb — especially if a spring is visibly broken
We look at both springs, the cables and the leaf weight on site
We replace the set matched to the door, not a single tired coil
We test balance by hand before the motor takes the leaf again
Final recommendations depend on the site. These are useful starting points.
Usually yes. The surviving spring has done the same work. Matching both to the door weight is general practice.
We will not fit a used coil as a spec. Springs are sized to the leaf; a leftover from another door is the wrong part.
No. Often the leaf is sound and the springs are the wear item. If the door is rusted or twisted, we will say replace.
Garage doors in Somerset West — supply-and-fit of sectional, roll-up and tip-up doors, plus motors. Site measure, photos of the opening, suburb. Not a kit shop.
Explore service ↗RELATEDGarage door repairs in Somerset West — stuck, off-track, noisy and motor faults. Site visit, photos of the door, suburb. Repair versus replace is a site call.
Explore service ↗RELATEDSectional garage doors in Somerset West — supply-and-fit of overhead sectional leaves. Short driveways, measured openings. Not a manufacturer catalogue.
Explore service ↗Share the service required, approximate extent, location and current condition. A quotation starts with a clear picture of the work.